Multiswitch Terra pass-through SRM-524 cu cale FM/DAB/DVB-T activă și AGC încorporat - sistem digital SCR/Unicable clasa…

The programmable SRM-524 R80524 multiswitch has one pair of Legacy /dSCR + DTT outputs. The outputs allow in dSCR mode for independent operation of up to 32 SAT dSCR receivers/STBs, fed in via two coaxial cables (16+16, default configuration) or via one coaxial cable (32 from one output in Unicable II standard, after reprogramming with the PC102W R80561 programmer) and through a distribution network based on typical passive satellite taps and splitters operating in the 5-2400 MHz frequency range. In Legacy mode, each of the outputs can be used as typical SAT output (like in Universal LNBs or standard (legacy) multiswitches) for connecting a legacy SAT TV receiver).The single-cable cascadable SRM-524 R80524 multiswitch allows for distribution of DVB-S/S2 signals from one satellite (or, using wideband LNBs, from two satellites) and terrestrial signals (DVB-T, DAB/FM radio). The satellite signals can be distributed by means of dSCR technology (digital Satellite Cable Router), requiring only one coaxial line and satellite splitters to provide the signals to compatible SAT receivers, along with terrestrial signals that can be received by standard televisions and radios. The cascadable SRM-524 R80524 multiswitch fully supports receivers operating in two dynamic modes: SCR (Unicable I - 8 User Bans) and dSCR (Unicable II - 32 User Bands). The SRM-524 multiswitch has 5 inputs (four polarization/band pairs (VL–HL–VH–HH) plus active terrestrial path (DTT)) and two outputs: dSCR (each allowing for independent operation of up to 16 SAT dSCR receivers/STBs fed via one coaxial cable - EN50607 standard) or operating as Legacy (typical SAT output like in Universal LNBs or standard (legacy) multiswitches for connecting a legacy SAT TV receiver). The built-in Automatic Gain Control (AGC) appropriately adjusts the multiswitch gain to ensure preset, constant output signal levels.By default, all outputs of the SRM-524 R80524 multiswitch are configured as Legacy (controlled by 14/18 V and 0/22 kHz commands from SAT receivers). Any output switches to Unicable dynamic mode after receiving DiSEqC command compliant with EN50494/EN50607 standard. This means that each individual output can feed via a single coaxial cable and 5-2400 MHz satellite splitters up to 16 receivers (EN50607).The device can operate in two modes; DYNAMIC - fixed output frequencies (User Bands) allocated for individual dSCR/Unicable receivers (distribution via single coaxial cable to up to 8 (EN50494 - UNICABLE I) or 32 (EN50607 - UNICABLE II) receivers); STATIC - fixed input and output frequencies, IF/IF conversion allowing for distribution of signals from 32 satellite transponders to an unlimited number of receivers (the practical limit results only from the attenuation of the passive distribution network).The programming of dSCR multiswitches is performed by the dedicated PC102W R80561 programmer.The die-cast housing provides high screening efficiency by preventing the penetration of interfering signals to the unit.The multiswitch should be powered from an external power supply, e.g. PS202F R71468 (20 VDC, 2 A).The table shows the default settings of the SRM-524 R80524 multiswitch (operation mode - DYNAMIC, 16+16 User Bands, Bandwidth, Level), which can be modified by the dedicated PC102W R80561 programmer.Key featuresBuilt-in LNB switch for selecting wideband or quatro LNBOne pair of dSCR/Legacy tap outputs DISEqC control connector allowing for connecting PC102W R80561 programmer and simultaneous configuration of all outputsFull compatibility with EN50494 standard - Unicable I - 8 UBs (User Bands) from each of the 4 pairsFull compatibility with EN50607 - Unicable II - 32 UBs (User Bands) from each of the 3 pairsAGC system ensures stable 84 dBμV output level in the SAT path and 82 dBμV level in the terrestrial pathPossibility of using receivers supporting EN50607 and EN50494 standards in the same subsystem (8 x EN50494 + 24 x EN50607)Power supply diagnostics by means of LEDs located on the device housing.There are many models of satellite receivers available on the market today. Not all of them support SCR/UNICABLE system compliant with EN50494 and/or EN50607 standard. In the case of implementing solutions based on the standards, all receivers that will be used by subscribers must support SCR/UNICABLE technology. As an example, a list of popular satellite receivers available in the Polish market and supporting single-cable multiswitches is provided below:Ferguson: Ferguson Ariva 154 Combo Ferguson Ariva 253 ComboFerguson Ariva 4K BlackFerguson Ariva 4K Combo BlackCyfrowy Polsat:Decoder HD 5000Decoder HD 5500s EVOBOX PVRnc+:BOX+mediaBOX+turboBOX+wifi Premiumbox+UltraBox NC+Recommended library article:Single-cable multiswitches -TERRA dSCR (Unicable system)<?xml version="1.0" encoding="utf-8"?>